Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Chimney Company in Campbell, CA
Chimney repair in Campbell usually starts with a camera. We get called to century-old bungalows near downtown with original clay-tile liners that have cracked from decades of thermal cycling, and to 1960s ranch homes off Hamilton Avenue where prefab metal flues have warped or separated. The mild Santa Clara Valley climate means most Campbell fireplaces sit dormant for months, so damage accumulates quietly until a homeowner notices water staining or a furnace backdraft. Chimney Sweep Almaden has served Campbell since 2017, and our repair work always begins with the same question: what does the flue actually look like inside? Call (833) 593-6691 when you want a straight answer.
Why Campbell Homes Are Different
Campbell’s chimney problems reflect its housing history. The downtown grid around Campbell Avenue and Winchester Boulevard still holds orchard-era bungalows built between 1900 and 1940, when Campbell was a fruit-packing town serving the surrounding apricot and prune orchards. Those homes typically have masonry fireplaces with single-wythe chimneys and original clay-tile liners. A century of California sun and the occasional earthquake leaves those tiles spalled, cracked, or shifted out of alignment.
A few blocks out, the picture changes. The post-war ranch tracts that replaced the orchards in the 1950s, 60s, and 70s were built with factory-made metal fireplaces and prefab flues. Those systems age differently, corroding at the seams and warping under heat. The mild, nearly frost-free climate means neither type gets heavy seasonal use, but that creates its own problem: dormant-chimney damage. Birds, squirrels, and raccoons move in during the long idle stretch, leaves accumulate, and creosote glazes rather than building up thick. By the time we’re called to a Campbell home in the 95008 or 95011 ZIP code, the issue is often structural, not just dirty.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Main Campbell Services
Campbell homeowners call us most often for two things: a thorough chimney sweep before the short burn season, and dryer vent cleaning after realizing their laundry has been taking twice as long to dry. Both are fire-safety services, and both are handled by the same specialist.
Chimney Sweep in Campbell
A sweep in Campbell starts with a Level 1 or Level 2 inspection, depending on what we find. In the older bungalows near the old cannery district, we’re checking clay-tile liners for hidden cracks. In the ranch tracts, we’re looking at metal flue seams and clearances. The mild climate means nests and leaf litter are as common as creosote, so we clear the full flue path, not just the firebox. If your fireplace has been sitting unused, that’s exactly when animals move in. Full details on our Chimney Sweep in Campbell page.

Dryer Vent Cleaning in Campbell
Dryer vent fires are one of the most preventable household risks, and Campbell’s single-story ranch homes often have long, horizontal vent runs through crawlspaces or walls. Lint accumulates at elbows and exterior louvers, restricting airflow until the dryer overheats. We clean the full run from the dryer collar to the exterior termination, then verify airflow with a pressure test. It’s a dedicated service, not an add-on. See our Dryer Vent Cleaning in Campbell page for specifics.

Chimney Repair in Campbell
Chimney repair in Campbell comes down to one recurring pattern: the flue has been damaged for longer than anyone realized. In the older downtown bungalows, original clay-tile liners crack under decades of heat stress, and water finds those cracks during winter rains. In the 1950s through 70s ranch homes, prefab metal flues corrode at the seams, and the flashing where the chimney meets the roofline deteriorates slowly. Because Campbell’s climate is so mild, the fireplace may still draw well enough to use, and the homeowner never suspects there’s a structural problem until we run a camera up the flue. That’s the value of a full-service Chimney Repair specialist: the person who finds the damage can also fix it, often the same week.
Chimney Cap Installation
Signs you need it
You hear animals in the chimney, you see water staining or debris inside the firebox, or your existing cap is rusted through and no longer keeping rain out.
What it costs in Campbell
A standard chimney cap installation in Campbell typically runs $290 to $510, depending on the cap size, material, and flue configuration.
How we do it
We measure the flue opening, select a cap with the right mesh size to exclude birds and squirrels, and secure it to the flue tile or chase cover with stainless hardware.
Chimney Cap Replacement
Signs you need it
The existing cap is pulling away from the flue, the mesh is chewed through or missing, or rust has eaten holes that let rain and spark carry into the flue.
What it costs in Campbell
Replacing a damaged chimney cap in Campbell typically costs $300 to $540, including removal of the old cap and disposal.
How we do it
We remove the failed cap, check the flue tile beneath for cracks or spalling, and install a replacement cap sized for proper draft and animal exclusion.
Chimney Liner Installation
Signs you need it
A camera inspection shows cracked or missing clay tiles, loose mortar joints, or discoloration that indicates flue gases have been leaking into the chimney chase.
What it costs in Campbell
Chimney liner installation in Campbell typically ranges from $2,440 to $5,100, with the spread driven by flue length, diameter, and whether the old liner must be broken out first.
How we do it
We size a DuraFlex stainless liner for the appliance and fuel type, insulate it where code requires, and run it from the appliance outlet to the flue top, then reconnect the termination and verify draft.
Chimney Flashing Repair
Signs you need it
You see water staining on the ceiling near the chimney, damp drywall in the attic around the flue chase, or rust-colored streaks on the exterior chimney.
What it costs in Campbell
Chimney flashing repair in Campbell generally runs $380 to $720, including removal of failed sealant, resetting loose flashing, and applying a proper two-layer flashing system.
How we do it
We pull back the damaged flashing, check the underlayment and sheathing for rot, install new step and counter-flashing where possible, and seal with a high-grade urethane caulk rated for exterior exposure.
What Chimney Repair Costs in Campbell
| Item | Typical range in Campbell |
|---|---|
| Chimney cap installation | $290 – $510 |
| Chimney cap replacement | $300 – $540 |
| Chimney liner installation | $2,440 – $5,100 |
| Chimney flashing repair | $380 – $720 |
In Campbell, prices climb when the flue needs scaffolding to reach a steep roof line on the two-story homes near downtown, or when a clay-tile liner must be chipped out before a stainless liner can go in. We quote flat prices after the camera inspection, so what we tell you is what you pay.
Does a cracked chimney liner need immediate replacement?
A cracked clay-tile liner should be addressed before you use the fireplace again. Even a small gap lets heat and combustion gases reach combustible framing. How urgent depends on the gap size and location, which a camera inspection tells us. Call (833) 593-6691 and we’ll show you exactly what the camera sees.
Can you repair a chimney crown without rebuilding the whole chimney?
Yes. A crown with minor cracking or spalling can usually be patched and resealed, especially if the mortar bed beneath is sound. If the crown has separated from the flue tile or eroded to the point of letting water into the chase, a full recast and crown repair is the better fix. We’ll tell you which one you need after seeing the condition up close.
Brands We Service in Campbell
We repair and install systems built around DuraFlex liners, HeatShield resurfacing, and components from Olympia Chimney and Copperfield. Parts for common Campbell fireplace models are stocked locally or sourced through our regular supply channels, so most repairs are completed same-week, not stretched over a month of part-hunting. See our brands for the full list.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Company in Campbell, CA
| Service | Typical range in Campbell |
|---|---|
| Chimney sweep (standard, one flue) | $180 – $340 |
| Chimney cap installation | $290 – $510 |
| Chimney cap replacement | $300 – $540 |
| Chimney liner installation | $2,440 – $5,100 |
| Chimney flashing repair | $380 – $720 |
| Dryer vent cleaning | $130 – $260 |
| Furnace flue cleaning | $180 – $320 |
In Campbell, price is driven upward by roof access on steep two-story homes near the downtown core, by flue length on taller chimneys, and by the need to break out an old clay liner before relining. We quote a flat price after inspection, so the number we give you is the number you pay. Call (833) 593-6691 to schedule.
Neighborhoods We Serve in Campbell
We work throughout Campbell and the 95008, 95009, and 95011 ZIP codes. Most sweeps and repairs are scheduled within a few business days, and we try to group Campbell jobs to keep travel time from inflating your quote.
- Downtown Campbell and the Cannery District
- John D. Morgan Park area
- San Tomas neighborhood
- East Campbell near Los Gatos Creek
- West Campbell off San Tomas Expressway
Service Area – Cities Near Campbell
From Campbell we regularly serve the surrounding Santa Clara Valley communities. Our nearest neighbors include Cambrian, CA to the south, Willow Glen, CA to the east, South San Jose, CA further down the valley, and Downtown San Jose, CA to the northeast. If you’re just outside Campbell, call and we’ll tell you straight whether we can get to you this week.
Serving Campbell, CA – Our Local Coverage Area
We’re based in the Campbell area and know this community well. Use the map below to see our service coverage – if you’re nearby, we can almost certainly help.
FAQs About Chimney Company in Campbell
Most Campbell jobs are scheduled within three to five business days, depending on the season. Repairs requiring parts from our Olympia Chimney or Copperfield supply lines may add a few days, but we’ll tell you the timeline before you commit to anything, not after.
Most chimney sweeps, cap replacements, and flashing repairs do not require a permit in Campbell. A full liner installation or any structural rebuild may, depending on the scope. If a permit is required, we’ll tell you during the inspection and handle the paperwork as part of the job.
We can and regularly do. The older bungalows near downtown Campbell often have masonry fireplaces with original clay-tile liners, and a camera inspection tells us exactly what condition the flue is in. We’ll show you the footage and explain whether the fireplace is safe to use as-is.
What happens when you call
- 1A real person answersNo phone trees. Talk to a local chimney cleaning pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you. The visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Campbell Customers Say
"Good work. The written inspection report took about a week to arrive after I asked for it, which was slower than I expected."
- Rafael Reyes"Cap keeps the birds out now, which after two springs of scratching noises is worth every penny."
- Emily Chen"Drop cloths everywhere, HEPA vac, and not a speck of soot on the carpet. I'd been dreading the mess for nothing."
- Veronica Torres